Results for kemo m142 led contant current source module
This LED with soldered constant current electronics may be connected at any voltage between 4â30 V/DC. The LED shines with almost constant brightness and has a consumption of ca.15 mA. An additional protective resistor is not required. The supplied LED can be exchanged for any other LED. It is...
Click For Info
Kemo-M142-Constant-Current-LED-Driver-Module-Kemo-M142-This-module-consists-of-an-LED-soldered-to-a-constant-current-circuit-It-can-be-connected-to-any-voltage-between-4-and-30V-DC-The-LED-shines-with-almost-constant-brightness-regardless-of-voltage-and-has-a-current-consumption-of-approx-15mA-No-ad...
Click For Info
This tester can be used to test light emitting diodes for all kinds of function, brightness, colour and polarity. The LEDs can optionally be tested with the following currents: 1 mA, 2.5 mA, 5 mA, 10 mA, 20 mA and 50 mA. The test contact can accommodate desoldered LEDs with solder residue on their...
Click For Info
After releasing the pushbutton, the light signal runs quickly round the 10 LEDs in a circle, slows and then stops randomly at one of the LEDs. All LEDs are lit during operation except for the LED currently receiving the signal. The illuminated circuit board looks very decorative.
Click For Info