Results for kemo m087n led tester module component

Kemo M087N LED Tester Module Component

Kemo M087n Led Tester Module Component

Kemo M087n Led Tester Module Component: This tester can be used to test light emitting diodes for all kinds of function, brightness, colour and polarity. The LEDs can optionally be tested with the following currents: 1 mA, 2.5 mA, 5 mA, 10 mA, 20 mA and 50 mA. The test contact can accommodate desoldered LEDs with solder residue on their pins as well as brand-new LEDs. 2 test sockets with the same current (10 mA) are arranged side by side for selecting LEDs of the same brightness.

Kemo M142 LED Constant Current Source Module

Kemo M142 Led Constant Current Source Module

Kemo M142 Led Constant Current Source Module: Kemo-M142-Constant-Current-LED-Driver-Module-Kemo-M142-This-module-consists-of-an-LED-soldered-to-a-constant-current-circuit-It-can-be-connected-to-any-voltage-between-4-and-30V-DC-The-LED-shines-with-almost-constant-brightness-regardless-of-voltage-and-has-a-current-consumption-of-approx-15mA-No-additional-protective-resistor-is-required-If-required-the-supplied-LED-can-be-substituted-for-any-other-similar-LED-It-is-also-possible-to-connect-several-LEDs-in-series-Kemo-M142-LED-Constan...

Kemo M048 Ultrasound Generator Module Component 12 - 15 VDC

Kemo M048 Ultrasound Generator Module Component 12 - 15 Vdc

Kemo M048 Ultrasound Generator Module Component 12 - 15 Vdc: Kemo-M048-Ultrasonic-Generator-Module-Kemo-M048-This-powerful-ultrasonic-generator-is-ideal-for-chasing-away-rats-mice-wild-rabbits-birds-etc-When-connected-to-a-suitable-piezo-speaker-the-module-produces-an-ultrasonic-tone-with-a-constantly-changing-frequency-Humans-can-usually-only-hear-frequencies-up-to-22kHz-so-only-the-animals-will-hear-the-sound-A-flashing-LED-on-the-module-indicates-when-it-is-in-operation-The-module-can-power-up-to-5-piezoelectric-speakers-Kemo-M048-Ultrasou...

Kemo M142 LED Contant Current Source Module

Kemo M142 Led Contant Current Source Module

Kemo M142 Led Contant Current Source Module: This LED with soldered constant current electronics may be connected at any voltage between 4–30 V/DC. The LED shines with almost constant brightness and has a consumption of ca.15 mA. An additional protective resistor is not required. The supplied LED can be exchanged for any other LED. It is also possible to connect several LEDs in series.

Kemo M114N Flasher Module with Adjustable Flash Sequence Component

Kemo M114n Flasher Module With Adjustable Flash Sequence Component

Kemo M114n Flasher Module With Adjustable Flash Sequence Component: Kemo-M114N-Bulb-Flasher-Module-with-Adjustable-Timing-Kemo-M114N-An-adjustable-flasher-module-for-incandescent-and-LED-bulbs-ideal-for-advertisements-warning-lights-party-lighting-model-lighthouses-etc-Flash-timing-is-variable-from-approx-0-6-to-9s-on-time-Kemo-M114N-Flasher-Module-with-Adjustable-Flash-Sequence-Component

Kemo M079 Flasher / Alternating Flasher Module

Kemo M079 Flasher / Alternating Flasher Module

Kemo M079 Flasher / Alternating Flasher Module: Kemo-M079-Flasher-Alternating-Flasher-Module-Kemo-M079-P-This-very-small-highly-integrated-flasher-module-can-directly-drive-up-to-10-light-emitting-diodes-LEDs-It-can-simultaneously-flash-one-or-several-light-emitting-diodes-or-flash-2-LEDs-or-LED-groups-alternately-The-module-is-short-circuit-proof-and-protected-against-reverse-polarity-P-P-Due-to-its-very-small-slim-design-this-flasher-is-also-suitable-for-sewing-into-clothing-as-well-as-for-use-in-models-and-toys-P-Kemo-M07...

Kemo M113A Time Switch

Kemo M113a Time Switch

Kemo M113a Time Switch: Kemo-M113A-Timer-Delay-Switch-Module-Kemo-M113A-Switches-on-other-devices-with-the-built-in-relay-contact-after-pushing-the-button-and-automatically-switches-them-off-again-after-a-set-time-The-time-can-be-stopped-any-point-by-pressing-the-second-button-Two-push-buttons-are-required-for-use-BR-Connection-via-flat-plug-on-the-module-middot-2-LED-display-1-x-LED-operating-voltage-1-x-LED-relay-ON-Kemo-M113A-Time-Switch

Kemo M167N Water Level Meter Module

Kemo M167n Water Level Meter Module

Kemo M167n Water Level Meter Module: Kemo-M167N-Water-Level-Meter-Module-Kemo-M167N-The-Kemo-M167N-water-level-meter-indicates-on-a10-level-LED-display-the-water-level-in-any-water-tank-where-it-is-not-immediately-possible-to-see-the-water-level-This-could-be-a-garden-water-butt-or-a-water-tank-on-a-caravan-or-boat-The-module-has-been-designed-to-be-attached-easily-to-walls-or-the-side-of-tanks-BR-BR-The-module-works-using-water-s-conductive-properties-by-submersing-a-multi-core-wire-in-the-water-tank-Each-of-up-to-10-cor...

Kemo M171 Speed Controller Component 9 - 28 VDC

Kemo M171 Speed Controller Component 9 - 28 Vdc

Kemo M171 Speed Controller Component 9 - 28 Vdc: Kemo-M171-DC-Speed-Controller-Module-9-to-28V-Kemo-M171-A-power-speed-controller-module-for-regulating-DC-loads-such-as-DC-motors-light-bulbs-heaters-LEDs-with-series-resistors-etc-Electric-motors-will-run-well-even-at-low-speeds-because-the-pulse-width-controller-feeds-them-with-full-voltage-but-in-short-bursts-Kemo-M171-Speed-Controller-Component-9-28-VDC

Kemo M085 Infrared Receiver

Kemo M085 Infrared Receiver

Kemo M085 Infrared Receiver: Kemo-M085-Infra-Red-Detector-Module-Kemo-M085-With-the-aid-of-this-infra-red-detector-it-is-possible-to-carry-out-functional-tests-on-infra-red-remote-control-units-infra-red-transmitters-and-light-barriers-etc-The-module-consists-of-an-infra-red-receiver-which-indicates-by-switching-on-an-LED-if-the-remote-control-on-test-emits-infra-red-radiation-It-is-suitable-for-most-infra-red-remote-controls-and-transmitters-The-detector-is-an-indispensable-piece-of-test-equipment-for-radio-and-...

Velleman MK137 IR Remote Tester Electronics Kit

Velleman Mk137 Ir Remote Tester Electronics Kit

Velleman Mk137 Ir Remote Tester Electronics Kit: Velleman-IR-Remote-Testers-Velleman-MK137-How-do-you-find-out-if-the-remote-control-for-the-TV-or-DVD-player-is-working-properly-With-the-Velleman-IR-Remote-Tester-Kit-you-have-the-answer-at-your-fingertips-Just-point-the-remote-at-the-sensor-and-push-an-arbitrary-button-Four-flashing-LEDs-indicate-remote-operation-The-Velleman-IR-Remote-Tester-is-also-available-as-a-pre-mounted-module-Velleman-MK137-IR-Remote-Tester-Electronics-Kit

Voltcraft CT-3 HDMI Cable Tester

Voltcraft Ct-3 Hdmi Cable Tester

Voltcraft Ct-3 Hdmi Cable Tester: Voltcraft-CT-3-Cable-tester-Voltcraft-CT-3-P-The-Voltcraft-CT-3-is-suitable-for-testing-the-inner-conductors-of-an-HDMI-cable-Proper-functioning-is-indicated-via-LEDs-The-cable-tester-can-be-grouped-into-two-separate-modules-so-already-installed-cables-can-be-easily-checked-P-Voltcraft-CT-3-HDMI-Cable-Tester

Level meter for water tanks, module M167N Kemo

Level Meter For Water Tanks, Module M167n Kemo

Level Meter For Water Tanks, Module M167n Kemo: This handy module for water storage units is a great aid for tracking your water supply Battery-powered level indicator is used to measure the level of water tanks such as rain water, clarification chambers and slurry tanks from distances of up to 100 m. The display is carried out at the push of a button via 10 LEDs in increments of 10% (display 10 - 100%). The unit can quickly and easily be mounted on a wall or post (approx. 131 x 78 x 36 mm) and requires 2 AA batteries. The electrical...