Results for kemo m142 led contant current source module
Kemo M142 Led Contant Current Source Module
Kemo M142 Led Contant Current Source Module: This LED with soldered constant current electronics may be connected at any voltage between 4â30 V/DC. The LED shines with almost constant brightness and has a consumption of ca.15 mA. An additional protective resistor is not required. The supplied LED can be exchanged for any other LED. It is also possible to connect several LEDs in series.
Kemo M142 Led Constant Current Source Module
Kemo M142 Led Constant Current Source Module: Kemo-M142-Constant-Current-LED-Driver-Module-Kemo-M142-This-module-consists-of-an-LED-soldered-to-a-constant-current-circuit-It-can-be-connected-to-any-voltage-between-4-and-30V-DC-The-LED-shines-with-almost-constant-brightness-regardless-of-voltage-and-has-a-current-consumption-of-approx-15mA-No-additional-protective-resistor-is-required-If-required-the-supplied-LED-can-be-substituted-for-any-other-similar-LED-It-is-also-possible-to-connect-several-LEDs-in-series-Kemo-M142-LED-Constan...
Kemo M087n Led Tester Module Component
Kemo M087n Led Tester Module Component: This tester can be used to test light emitting diodes for all kinds of function, brightness, colour and polarity. The LEDs can optionally be tested with the following currents: 1 mA, 2.5 mA, 5 mA, 10 mA, 20 mA and 50 mA. The test contact can accommodate desoldered LEDs with solder residue on their pins as well as brand-new LEDs. 2 test sockets with the same current (10 mA) are arranged side by side for selecting LEDs of the same brightness.
Kemo B239 Wheel Of Fortune Kit
Kemo B239 Wheel Of Fortune Kit: After releasing the pushbutton, the light signal runs quickly round the 10 LEDs in a circle, slows and then stops randomly at one of the LEDs. All LEDs are lit during operation except for the LED currently receiving the signal. The illuminated circuit board looks very decorative.